0
$0.00
  • An empty cart

    You have no item in your shopping cart

SR-1104 Weatherseal Installation Instructions

SR-1104 has three parts that work together: the cap, the retainer and the fin seal. Install the header first, then the two side seals, then snap the caps back on and fasten them.

⬇ Download printable instructions (PDF)

Part 1: Header

1

Cut the header to size

Measure across the top of the door opening and cut the header piece to length.

2

Pin the fin and install screws

Pin the fin seal so it can’t shift in the retainer, then install the screws to fasten the header in place.

3

Snap the cap back on

Press the cap back onto the header retainer until it snaps in, working along the full length.

Part 2: Side Seals

4

Cut the side seals to size

Measure the jamb height and cut each side seal to length. Repeat for the opposite jamb.

5

Pin the fin at top and bottom

Pin the fin seal at the top and at the bottom of each side seal.

6

Install screws in the retainer

Drive screws through the retainer to fasten each side seal to the jamb, working down its length.

Part 3: Snap the Caps On and Fasten

7

Snap the side caps on

Insert the cap by pushing it straight into the jamb until it snaps onto the retainer.

Cross-section of the SR-1104 cap snapped onto the retainer, with a screw through the flex
8

Cap screw 1: 1" from the top

Using #8 or #6 self-drilling screws, fasten the first screw through the flex, 1" down from the top.

Top of the side seal showing screw 1 at 1 inch from the top and screw 2 at 4 inches below it
9

Cap screw 2: 4" below screw 1

Fasten the next screw 4" below the first screw.

10

Cap screw 3: 1" from the bottom

Fasten the third screw 1" up from the bottom.

Bottom of the side seal showing screw 3 at 1 inch from the bottom and screw 4 at 4 inches above it
11

Cap screw 4: 4" above the bottom screw

Fasten the last screw 4" above the bottom screw.

12

Repeat on the other side

Repeat steps 7 to 11 on the opposite side seal. Each side should have 4 cap screws.

Why the cap screws matter: they’re optional but recommended. Without them, the cap can shrink in high heat, such as with dark-coloured weatherstrips, aluminum-clad jambs or dark aluminum jambs. The screws also stop the flexible part of the weatherstrip from creeping up or down.

Storage: please do not leave weatherstripping in polybags exposed to the elements.

Need help?
Call 1-800-297-8299 or email sales@eltonmanufacturing.com.

Video Coming Soon…